K8033 INSTALLATION PHOTOS

$0.00
Sold Out


Calculate Shipping



Courier Delivery - $0.00
Road delivery Australia wide.
Australia Post eParcel - $0.00

Please check the pictures below to help with the installation. The long sides are 10mm higher than the short sides. 
 
Their should be 6 cushion sides 4 the same and 2 other sides that are the same. The 2 identical sides are the end panels. If you can find these 2, the others should fit perfectly and align with the pockets to form a standard size ball hole.

For the leveling of the slates, you need lay cardboard / washers / timber strips underneath the slate to level it, using silicon to seal the gap and levelling with sandpaper / chisel.
 
For the slates, there are a few things we need you to consider. 
 
As our slates are made out of mountain stone, produced into slates and send from China to Australia, small chips and cracks are fairly common. We have taken this into account and thus we have the wooden board underneath it to hold it in place even if it splits. 
 
This is so that the slate is usable after applying a few touches of silicon sealant (please see the attached picture). Using the silicon or no more gaps is necessary in installing the pool table anyway, so it will only be another step in the process.  
 
After the felt is applied and full assembly is complete, there should be no extra roll on the top from where the crack/split was, it should be completely smoothed out from the above process.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

(K8033-INSTRUCTION)

SKU K8033-INSTRUCTION
Shipping Weight 0.2000kg

Be The First To Review This Product!

Help other K-Sports users shop smarter by writing reviews for products you have purchased.

Write a product review


Others Also Bought



More From This Category